Computer with DFP output to TFT/LCD digital display with DVI input!
DFP (Digital Flat Panel) interface uses an MDR20 (Micro Delta Ribbon) connector, which allows only digital signal transfer. It is restricted to resolutions up to 1280 x 1024.
DVI (Digital Visual Interface) uses a DVI connector, which allows digital or analogue signal transfer. It incorporates a second digital link (Dual Link) which allows resolutions up to 1920 x 1080.
- MDR20 Male to DVI-D (Digital) Female
- For use with modern TFT (Thin Film Transistor)/LCD (Liquid Crystal Display) Flat Panel Displays
- Cables and adaptors are available from LINDY for the three most common video interfaces used today
- 10 Year Warranty
- Reduced interference from one piece EMI (Electromagnetic Interference)/RFI (Radio Frequency Interference) shield
- Increased insulation resistance up to 25%
- No soldering requirements as interconnect design needs no 360 degree soldering - eliminating the possibility of human error and/or cracking of the solder that causes grounding intermittence and the use of the most hazardous waste material - soldering flux
- Tight fit of internal wires as there is no inner mould
- No requirement of ferrite cores as signal loss and degradation are greatly reduced giving enhanced signal sharpness. Without the ferrite cores the cable is less stressed and more flexible
- Smaller overall dimensions which allows more room behind the host or peripheral
- Increased connector and mating strength - the 4 point reinforcement tabs on the RF-BLOK, attached to the connector, strengthens the pair as one
Cables 
Audio / Video Cables 
)
